air locking differential

ARB, Air Locking Differential

• One solution is the Positive Traction (Posi), the most well-known of which is the clutch-type. With this differential, the side gears are coupled to the carrier via a multi-disc clutch which allows extra torque to be sent to the wheel with higher resistance then available at the other driven roadwheel when the limit of friction is reached at that other wheel. Below the limit of friction more torque goes to the slower (inside) wheel.

• A limited slip differential (LSD) ar anti-spin is another type of traction aiding device that uses a mechanical system that activates under centrifugal force to positively lock the left and right spider gears together when one wheel spins a certain amount faster than the other. This type behaves as an open differential unless one wheel begins to spin and exceeds that threshold. While positraction units can be of varying strength, some of them with high enough friction to cause an inside tire to spin or outside tire to drag in turns like a spooled differential, the LSD will remain open unless enough torque is applied to cause one wheel to lose traction and spin, at which point it will engage. A LSD can use clutches like a posi when engaged, or may also be a solid mechanical connection like a locker or spool. It is called limited slip because it does just that; it limits the amount that one wheel can "slip" (spin).

• A locking differential, such as ones using differential gears in normal use but using air or electrically controlled mechanical system, which when locked allow no difference in speed between the two wheels on the axle. They employ a mechanism for allowing the axles to be locked relative to each other, causing both wheels to turn at the same speed regardless of which has more traction; this is equivalent to effectively bypassing the differential gears entirely. Other locking systems may not even use differential gears but instead drive one wheel or both depending on torque value and direction. Automatic mechanical lockers do allow for some differentiation under certain load conditions, while a selectable locker typically couples both axles with a solid mechanical connection like a spool when engaged.

• A high-friction 'Automatic Torque Biasing' (ATB) differential, such as the Torsen differential, where the friction is between the gear teeth rather than at added clutches. This applies more torque to the driven roadwheel with highest resistance (grip or traction) than is available at the other driven roadwheel when the limit of friction is reached at that other wheel. When tested with the wheels off the ground, if one wheel is rotated with the differential case held, the other wheel will still rotate in the opposite direction as for an open differential but there with be some frictional losses and the torque will be distributed at other than 50/50. Although marketed as being "torque-sensing", it functions the same as a limited slip differential. 3D Animation of a Torsen Differential

• A very high-friction differential, such as the ZF "sliding pins and cams" type, so that there is locking from very high internal friction. When tested with the wheels off the ground with torque applied to one wheel it will lock, but it is still possible for the differential action to occur in use, albeit with considerable frictional losses, and with the road loads at each wheel in opposite directions rather than the same (acting with a "locking and releasing" action rather than a distributed torque).

• Electronic traction control systems usually use the anti-lock braking system (ABS) roadwheel speed sensors to detect a spinning roadwheel, and apply the brake to that wheel. This progressively raises the reaction torque at that roadwheel, and the differential compensates by transmitting more torque through the other roadwheel—the one with better traction. In Volkswagen Group vehicles, this specific function is called 'Electronic Differential Lock' (EDL).

• A Spool is just what it sounds like. It may replace the spider gears within the differential carrier, or the entire carrier. A spool locks both axle shafts together 100% for maximum traction. This is typically only used in drag racing applications, where the vehicle is to be driven in a straight line while applying tremendous torque to both wheels.

• In a four-wheel drive vehicle, a viscous coupling unit can replace a centre differential entirely, or be used to limit slip in a conventional 'open' differential. It works on the principle of allowing the two output shafts to counter-rotate relative to each other, by way of a system of slotted plates that operate within a viscous fluid, often silicone. The fluid allows slow relative movements of the shafts, such as those caused by cornering, but will strongly resist high-speed movements, such as those caused by a single wheel spinning. This system is similar to a limited slip differential.

A four-wheel drive (4WD) vehicle will have at least two differentials (one in each axle for each pair of driven roadwheels), and possibly a centre differential to apportion torque between the front and rear axles. In some cases (e.g. Lancia Delta Integrale, Porsche 964 Carrera 4 of 1989^[7]) the centre differential is an epicyclic differential (see below) to divide the torque asymmetrically, but at a fixed rate between the front and rear axle. Other methods utilise an 'Automatic Torque Biasing' (ATB) centre differential, such as a Torsen—which is what Audi use in their quattro cars (with longitudinal engines).
4WD vehicles without a centre differential should not be driven on dry, paved roads in four-wheel drive mode, as small differences in rotational speed between the front and rear wheels cause a torque to be applied across the transmission. This phenomenon is known as "wind-up", and can cause considerable damage to the transmission or drive train. On loose surfaces these differences are absorbed by the tire slippage on the road surface.
A transfer case may also incorporate a centre differential, allowing the drive shafts to spin at different speeds. This permits the four-wheel drive vehicle to drive on paved surfaces without experiencing "wind-up"..